Jul 30 2008
Cut Your Energy Costs
As seen on KXLY4 News at 5 Wednesday
Cut Heating and Cooling Costs (additional suggestions here)
Program your thermostat to turn heat down or air-conditioning up when you’re out. If your furnace is more than 10 to 15 years old, or your boiler is more than 20 years old, replace it with a model approved by the federal government’s Energy Star program (marked by rating stickers in stores). It will pay for itself in energy savings in 5 to 10 years.
Cut Lighting Costs (additional suggestions here)
Replace regular incandescent bulbs and fixtures with Energy Star-qualified compact fluorescent lights (CFLs), available at most hardware stores. CFLs cast a warmer glow than the cold, harsh fluoros of old. They cost more than regular bulbs, but they use 70 percent less energy, last much longer (10,000 hours, compared with 750), and look just as good.
Cut Home Electronics Energy Costs (additional suggestions here)
Unplug DVD players and TVs, or plug them all into a power strip you can switch off. Sixty to 80 percent of the electricity they use is consumed while they’re idle, powering light displays and “instant on” features (such as the remote’s ability to talk to the TV).
Cut Appliance Energy Costs (additional suggestions here)
Replace an old refrigerator. One made before 1993 could be costing $140 a year in electricity. Even refrigerators built between 1993 and 2001 cost about $60 a year to run. A new Energy Star-rated model runs on about $20 worth of electricity. A new $600 refrigerator will last for decades and could pay for itself in less than five years. For efficient chilling, keep the refrigerator full, remove things stored on top of it, and clean the condenser coils annually.
(No Ratings Yet)
Loading ...
CFLs are made only in China. Once again they will be laughing all the way to the bank. We have all heard about the lead in many of their products but the CFLs have mercury in them. Here’s the clean up instructions in case you break a CFL. This is from the EPA website.
* Have people and pets leave the room, and don’t let anyone walk through the breakage area on their way out.
* Open a window and leave the room for 15 minutes or more.
* Shut off the central forced-air heating/air conditioning system, if you have one.
* Carefully scoop up glass pieces and powder using stiff paper or cardboard and place them in a glass jar with metal lid (such as a canning jar) or in a sealed plastic bag.
* Use sticky tape, such as duct tape, to pick up any remaining small glass fragments and powder.
* Wipe the area clean with damp paper towels or disposable wet wipes. Place towels in the glass jar or plastic bag.
* Do not use a vacuum or broom to clean up the broken bulb on hard surfaces.
* Immediately place all clean-up materials outdoors in a trash container or protected area for the next normal trash pickup.
* Wash your hands after disposing of the jars or plastic bags containing clean-up materials.
* Check with your local or state government about disposal requirements in your specific area. Some states do not allow such trash disposal. Instead, they require that broken and unbroken mercury-containing bulbs be taken to a local recycling center.